Boho Chic Earrings
Have trouble finding just the right color for that super sporty blouse or looking for the right simple but elegant drop for a summer date night??? Well, Look No more.
You can customize the material (this was done on an AMS with 2 color PLA) and / or your color . You will only be limited by the color you choose to make (this timegrin)
These are designed as a DUAL color option (if you have an AMS) but you can erase all painting in the bambu studio and paint them however you would like
The file has a length (before jewelry findings) of 1.5in L by 1.00 in W. Its only about 1/8 of an inch thick and even at 30% infill-SUPER light on your ears This piece can be successfully sized slightly up (do not recommend you go down due to hole for jump ring)
The jump ring gage (how thick the wire that they make the jump ring from) is 18-20 (i used 20 )-the diameter of the ring is up to you (mine were 6mm). As far as the earring part-you can attach to fishook type, post type or even clip earring findings. These can all be found on amazon or crafts stores like Michaels/Hobby Lobby or JoAnns. Even Walmart sells jewelry findings as well
Print Time for a single pair (2 earrings) is about 67 Min
P1P/ Bambu Basic Aux fan should be turned down to around 20 or 30 % (or off)
Settings First Layer .16mm Other layers .16mm elephant foot compensations .1 Ironing is turned on for top surfaces Arachne Walls 2 wall loops 6 top shell 4 bottom shell 30% Grid Speed Initial layer lowered to 30 and Initial infill 85
Prime tower enabled Flush into model /support turned off Brim/Bed Adhesion: None Needed Filament flushing set for 1.00 (you will need to adjust this for your filaments and machine type)