Build your own modern standing lamp.
Fits a Bambulab X1 or P1 series
Print settings: _Shade: _ prints in vase mode (0.8mm nozzle recommended; 0.4 possible) or normal mode (0.4mm nozzle) layer height 0.56mm (0.8mm nozzle) or 0.28mm (0.4mm nozzle) in both cases print it upside down and set bottom layers to 2 (0.8) or 4 (0.4) 2 options for 0.4mm nozzle: vase mode: set line width to 0.7/0.8mm; 4 bottom layers normal mode: 2 walls; 4 bottom layers; 0% infill; 0 top layers add height range modifier: 0.96mm to 300mm --> 0 bottom layers
Top: prints upside down 0.2mm layer height 3 walls minimum Cap: 0.2mm layer height 2 walls 1 bottom layer 0 top layer 30% gyroid add height range modifier: 0% infill after 1mm
Filament: For the shade use some whiteish filament. I used Spectrum PLA Ivory Beige.
Additional hardware: 3x wood rods diameter=28mm L=1370mm 6x wood screw 3,5mm 1x zip tie 1x E14 or E27 light cord