tracking pixel
GOODesign

Foldable jack O lantern - Trans face V 1.1

by
GOODesign
Follow
Follow
Remix Model
GOODesign
GOODesign
|
Image 1 of 4
Foldable jack O lantern - Trans face V 1.1 3d model
GOODesign
GOODesign
|
Image 1 of 4
Foldable jack O lantern - Trans face V 1.1 3d model
2D
3D
Makes
Foldable jack O lantern - Trans face V 1.1 3d model
Foldable jack O lantern - Trans face V 1.1 3d model
Foldable jack O lantern - Trans face V 1.1 3d model
Foldable jack O lantern - Trans face V 1.1 3d model

I designed it for the coming Halloween day. This jack o lantern is very simple, consisting of two parts: the body and the stem. This design is made with thin shapes of eyes, nose and mouth for stable printing and soft lighting effect.

※ There is logo on the side ※ ※ The stalk of the transparent face and the cut off face are different. Only one stalk is included. Be sure to check. ※

The assembly method is very simple, just insert the ends of the body pieces one by one on the stem.

One thing to note when printing is that there is a risk that the outer parts will fall off during printing. Therefore, pay attention to bed / plate adhesion. If your bed / plate adhesion is not good, I recommend using Raft.

To insert the LED tea candle inside, pull out three strands of the body, insert the LED tea candle, and insert the remaining body pieces.

LED tea candles are sold in Ikea as GODAFTON, MOGNAD, STOPEN. The size of the LED tea candle is about 40 mm in diameter. Even if it is not a product of IKEA, you can put it inside if it is an LED tea candle. Have a great Halloween day.

When expanded, size = X 137mm, Y 184mm, Z 53mm After folding X 89mm, Y 87mm, Z 87mm

Design by GOODesign


1 Likes0 DownloadsOctober 30, 2024


1 Likes0 DownloadsOctober 30, 2024