I needed a mount for this power supply in my workshop after another power supply was found to be inadequate. This was made from a scan with a Revopoint POP2, post-processed in RevoScan and ExModel Lite. The fit is superb and very snug.

There are two versions, one that mounts via a single screw hole, ideal for hanging from walls or other things and one with two screw holes on each side, so it can be mounted easily in other orientations.

Safety note: This power supply gets warm, so you need to make a judgement call as to if this is safe to use in your environment. If the power supply overheats it may be a safety issue.

The holes in each model are 5.4mm wide.

Both models print with no supports and slip on snugly to the device. There are some holes to help heat escape. I used Fillamentum Flexfill 98A for my print but any TPU will probably do.

If you find this model useful it would be great if you can support me by subscribing to me here, if only for a month. Thank you!