Set of 4 home decor ornaments with built in mounting puck slot. When these are viewed from straight on they all take on the same shape, but they each have differing angles when viewed from the side.

The fifth file included in this model is the French Cleat Puck. This is what you screw to the wall, once you have the Puck screwed to the wall you can slide the Ornament onto the puck and push until it snaps into place. This was designed this way so that if you apply slight upward pressure to the ornament after mounting, it doesn't want to fall off of the wall as easily.

The pictured versions shown here were printed with Hatchbox PLA Terracotta filament. No supports needed, the inside section of the French Cleat has overhang, but prints decently on most printers without supports, there are room for defects here and it is not visible at all when mounted.

I use these to hang my beanies on next to the front door.

Buy models as an individual pack or get for free when you sign up for our "Full Access" membership