Jonathan P

Mushroom Keychain - Amanita Muscaria - Multicolor

by
FunPrints3D
Follow
Follow
Remix Model
FunPrints3D
FunPrints3D
|
Image 2 of 2
Mushroom Keychain - Amanita Muscaria - Multicolor 3d model
FunPrints3D
FunPrints3D
|
Image 2 of 2
Mushroom Keychain - Amanita Muscaria - Multicolor 3d model
2D
3D
Makes
Mushroom Keychain - Amanita Muscaria - Multicolor 3d model
Mushroom Keychain - Amanita Muscaria - Multicolor 3d model
This model is restricted by licensing terms. 

This is a fun little keychain that is made to look like an Amanita Muscaria mushroom or toadstool, one of the most recognizable fungi there is.

This is made to go on a 1 inch keyring, but it may fit some smaller keyrings as well. You could put it on a string and use it as a pendant as well.

In Bambu Studio, I would recommend normal supports at a threshold angle of ~15 In Cura I would recommend normal supports at ~70 degrees

25% infill and .15mm layer lines.

Have fun printing and enjoy!


11 Likes34 DownloadsSeptember 27, 2024


11 Likes34 DownloadsSeptember 27, 2024
This model is restricted by licensing terms.