F

Rear view mirror brace for Nissan NV200

by
FullMetalBaker
Follow
Follow
Remix Model
F
FullMetalBaker
|
Image 2 of 8
Rear view mirror brace for Nissan NV200 3d model
F
FullMetalBaker
|
Image 2 of 8
Rear view mirror brace for Nissan NV200 3d model
2D
3D
Makes
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model
Rear view mirror brace for Nissan NV200 3d model

This is my take on the brace of my NV200 (2012) that broke. Inspired from Matsugawa on Thingiverse: https://www.thingiverse.com/thing:4211846

Was using Matsugawa's model for more than a year in the car which i had printed in PETG and it held up great. It was a tad bit bigger than the mirror and because of that i found it as an excuse to challenge my Freecad skills. The nut is an 8mm, and the bolt i found and used wasn't the greatest because i had to groove it with the angle grinder to fit the screwdriver.

Printed in PLA+ 10% infill and 3 walls. Due to the stress of the screws and the heat of the sun it wont last long. I propose PETG or ABS ASA 25% infill and 3 walls.

Might improve the design a bit more in the future to make it look more than the original part.


0 Likes4 DownloadsDecember 31, 2023



0 Likes4 DownloadsDecember 31, 2023