This is an axolotl from Minecraft riding upon a wave.

It prints in two parts, the wave and the axolotl so the file contains two plates.

The water prints without supports but the axolotl prints with quite a few some of which are a bit tougher to remove so be careful with those.

Also in the images, two of the head tentacle-ey things have been glued on but they print fine, I just immediately dropped it as soon as it had printed so that is the reason for that.

The axolotl does balance on the water but if you don't want to have them separately I would recommend gluing them.

This file is a 3mf for bambu studio

I would recommend printing the water in PETG translucent blue- that is what I used.

hope you like it and enjoy and if you do, check out the other Minecraft models on my account.

Thanks!