Easy to print with multiple designs for subscribers and free blank wallet for all members.
Designs included for subscribers is the cute chibi unicorn, toothless smiley, futurama fry 'take my money' & the cartoon grinning toothless - hand drawn by my partner and tuned into this 3D design.
Can be built in about 30 seconds and only requires a tiny amount of glue to hold the body with is easily positioned with 4 locator slots.
To assemble place the stepped mechanism in the wallet front aligned with hole then stack the card holders accordingly to right of the mechanism - the carefully line the top up with the 4 small locator holes with a tiny amount of glue ensuring not to spread glue on the inside of the wallet - lastly place the handle through the body and mechanism aligned with the cutout and place the locking pin through on the opposite side.
To print, use standard BambuLab settings. To anyone using Cura etc..
Wall height 2.0
Wall thickness 0.42 per wall (2 walls)
Gyroid minimum 15% infill
No brim or support
Speed according to your filament requirements
Silk only for the outside body if you want to use silk - the inside mechanism and handle are better suited to regular PLA
I have included extra wallet sized inserts due to filament and printer differences, I noticed the A1 had extra filament shrinkage causing the body to be tight, I recommend printing the extra low tolerance wallets and testing before to ensure your setting are tuned, if they're still too tight the outside case can be scaled up easily but it's not a problem I had.
I tested over 30 times successfully and it worked beautifully but any issues just ask and I will help the best I can, I hope you like it )