Really pleased with how these turned out.

For this halloween ive made the sitting eyeball. designed to sit on a shelf with the legs hanging over.

while its a multi colour print as always you can print single colour and paint. or fill a build plate to sell.

Be careful with flushing volumes and colour of filaments.

the above model uses Bambu red and i had no bleeding on standard flushing volumes. However i also tried using eSun fire engine red and even increasing flushing volumes i still had bleeding.

in the 3mf profile i have adaptive layer height turned on to smooth out the spare, this of course does add a lot of time but a much nicer finish.

please ensure good adhesion on the hands as they print separately until they join the body. if your concerned please use a brim or glue.

0.2 or o.16 layer height, 10% infill