From creating the Beetlejuice themed dragon and then making a sandworm the natural evolution was to make the Beetlejuice sandworm inspired by the Beetlejuice movies of course. the making of this wasn't without issue at printing stage. incorrectly sizing the ball and socket joint to the first printing with lines. the second test print fixed any issue and im now able to release. The head is a long print in multi colour. Most of the model is separate pieces for easy colouring should you want to paint differently. the head prints upright with supports. in terms of supports set the top z distance to 0.3 if using 0.2 layer height. the supports should then just twist off. The body prints without supports.. The ball and socket joint is tight so there is friction once inserted. Be careful when pushing it in. Gently rotate round while pushing and should pop in. You can consider using just a touch of heat to soften the plastic a little, but sparingly as its easily warped. 3D PRINTING SETTINGS 0.2 layer. reduce infill for better sounds
- So for those that sell. I am placing the legalities of selling this model in your hands, i take no responsibility if you choose to sell this item