tracking pixel
IoT M

Ender 3 s1 pro stock fan duct upgrade

by
EngineerMeThis
Follow
Follow
Remix Model
EngineerMeThis
EngineerMeThis
|
Image 1 of 5
Ender 3 s1 pro stock fan duct upgrade 3d model
EngineerMeThis
EngineerMeThis
|
Image 1 of 5
Ender 3 s1 pro stock fan duct upgrade 3d model
2D
3D
Makes
Ender 3 s1 pro stock fan duct upgrade 3d model
Ender 3 s1 pro stock fan duct upgrade 3d model
Ender 3 s1 pro stock fan duct upgrade 3d model
Ender 3 s1 pro stock fan duct upgrade 3d model
Ender 3 s1 pro stock fan duct upgrade 3d model

Summary So the cooling fan/mount on the S1 pro is horrible. Here is a very simply upgrade,

Simply remove the fan, flip the stainless steel bracket 180 degrees and mount back with two of the mounting holes.

Obviously after you have printed and replace the fan shroud.

No need to upgrade any fan, just make sure you undo the cable relief behind the fan and it will still reach the connector port as expected.

You will see once the new shroud is in place the nozzle is slightly off center. this is expected. one port of the shroud points at the printed point, and the other at the area just off the side. meaning the melted plastic gets blast of air just as its laid down, and another blast when head moves past that point.

Printer: Ender-3 v2

Rafts: Yes Supports: Doesn't Matter Resolution: 0.2 or 0.28 Infill: 100% Filament brand: Generic

Filament color: black

Filament material: PLA

Notes: Print on fan vent ports like image below with Brim, I didnt need support but you might.


6 Likes21 DownloadsFebruary 26, 2024


6 Likes21 DownloadsFebruary 26, 2024