This is a model of a spaceship people transporter I designed in Tinkercad. It should be printed standing up so a brim is recommended for first layer adhesion.

spaceship people transporter

This is a model of a racing spaceship that I designed in Tinkercad. The engines are detachable and slot into a holder that slots into the main section of the model

A brim is recommended to prevent the model from falling over during printing.

The correct printing orientation is with the front of the spaceship facing down.

racing spaceship with detachable engines

racing spaceship detachable engines

This is a model of a spaceship engine I designed in Fusion 360. There is a section of the engine that prints in place inside the bottom of the model that is then free to move up and down when the model is done. This model is scalable.

A brim is recommended to make sure the model does not fall over during printing.

At 100% scale there is a defect with the thin perimeters at the top of the model if you have detect thin walls enabled, to fix this just disable that feature.

fusion 360 engine

This is a model of a spaceship docking station that I designed in Tinkercad. It is printed in three separate pieces two of which need to be joined together while the third part, the ring, will be able to spin freely around the main part.

A brim is recommended on the large upright part so that it does not fall over during printing.

Some sanding might be required to get the parts to fit together properly.

Spaceship docking station

The ring and lower section of the docking station

docking_station_part_1.stl

This is a model of a spaceship engine with an aerospike that I designed in Fusion 360. The 4 support tags that hold the spike in place need to be cut off after the print is finished for the design to function.
Since the model is printed standing up, a brim is recommended.

aerospike spaceship engine

This is a model of a space car that I designed in Tinkercad.
The model is printed upright with the engine on the buildplate so a brim is recommended. 

flying car concept

This is a model of a space car that I designed in Tinkercad.

space car concept

I am a young maker who loves CAD and 3D printing. I'm not a professional but I like to make models, especially anything to do with spaceships.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

DrHazmat24

Achievements