I could not get the standard Multiboard pegboard click hooks to hold my rubber mallet the way I wanted, so I put together this custom click hook for holding a rubber mallet with a head diameter of 65mm or less.
Printing The printing orientation is as provided in the file. Use standard Multiboard printing parameters (0.2mm layer height, 3 perimeters, 15% infill).
Assembly/Installation Install two of these on the same horizontal, leaving one column of pegboard holes between them. If your mallet is wider, you may need to leave two empty columns between them. Do not push on the curved/pointed end when installing or it may snap; despite this, I assure you it's strong enough to securely hold your rubber mallet once installed!
Thanks to Keep Making for the excellent Multiboard system.