tracking pixel
Jahn B

Corne Case - Magnetic, Low Profile, Large Battery

by
Codethetical
Follow
Follow
Remix Model
Codethetical
Codethetical
|
|
Image 1 of 11
Corne Case - Magnetic, Low Profile, Large Battery 3d model
Codethetical
Codethetical
|
|
Image 1 of 11
Corne Case - Magnetic, Low Profile, Large Battery 3d model
2D
3D
Makes
Corne Case - Magnetic, Low Profile, Large Battery 3d model
Corne Case - Magnetic, Low Profile, Large Battery 3d model
Corne Case - Magnetic, Low Profile, Large Battery 3d model
Corne Case - Magnetic, Low Profile, Large Battery 3d model
Corne Case - Magnetic, Low Profile, Large Battery - Another view of the nice!view and bodge wire on the top side. - 3d model
Corne Case - Magnetic, Low Profile, Large Battery - The nice!view on the top side of the PCB with black foam tape slightly visible underneath. - 3d model
Corne Case - Magnetic, Low Profile, Large Battery - The nice!nano v2 is soldered directed onto the bottom side of the PCB and the nice!view is soldered onto the front with bare wires with a gap of 2mm given by two layers of 1mm foam tape. The yellow wire is the nice!view CS pin bodge wire. - 3d model
Corne Case - Magnetic, Low Profile, Large Battery - The completed Corne PCB inside the case top after trimming the screw posts. - 3d model
Corne Case - Magnetic, Low Profile, Large Battery - Carefully trimming the screw posts with flush cutters. - 3d model
Corne Case - Magnetic, Low Profile, Large Battery - This shows the nice!nano soldered onto the underside of the PCB. - 3d model
Corne Case - Magnetic, Low Profile, Large Battery 3d model

This is a case for the corne/crkbd split keyboard which features magnetic attachment between the halves and a low profile design despite capacity for a 1150mAh battery. The design is intended to be printed in its normal orientation rather than upside down, so the columns that receive the case screws extend all the way to the build plate and must be carefully trimmed with flush cutters. These columns are radiused at their base to help prevent them snapping up when removing supports. This case is designed to work with this lipo cell which is only 4mm thick. Also, the case is designed to fit the nice!view rather than a typical OLED screen. The screws for this case are M2.5x8mm with countersunk heads. The battery connectors are these, because they are exceedingly flat. The nice!view screens are mounted with two laters (2mm) of this double-sided tape to get the right offset between the PCB and the top of the case. The nice!nano controller and the reset button need to be mounted to the bottom of the PCB for everything to fit correctly. Lastly, the stabilizing pillar between the reset button and on/off switch needs to be trimmed to fit with flush cutters depending on whether it touches the microcontroller.


19 Likes110 DownloadsJuly 12, 2023


19 Likes110 DownloadsJuly 12, 2023