This is one of my new favourites! The 30 fins look really good and can be printed in any colour. This can be used as a candle holder or simply a nice sculpture.

Supports: None!

Scaling: I haven't tried scaling, but will release different size options (if you are after anything in particular, DM me!)

Orientation: Orientate each Fin so that the Number is facing UP. No supports are needed, and the Numbers are just to speed up the assembly process. Orientate the Upper and Lower plates so that they don't require any supports.

Print Settings 0.2mm layer height 15% grid infill 2 walls

Filament: I use: Overture PLA in any colour

Downloading this 3D model is for personal, non-commercial use. If you would like to explore commercial opportunities, DM me for further discussion.