ORIGAMI PIP | print-in-place Table Lamp E14, E26, E27
byCharlesRegaudORIGAMI PIP | Table Lamp E14, E26, E27 print-in-place
(NOTE: this version is available at no extra-cost to those who already purchased the tripod-mounted Origami lamp)
A brand new twist on the ORIGAMI table lamp. This version is 100% print-in-place and 100% free-standing. No need for a base/stand.
Just mount your E14 or E26 or E27 bulb sockets directly where the shade's inner shell narrows into a mounting neck in the middle.
2 sizes available:
- the original Large version (height 250mm)
- and a Small version (height 209mm) to accomodate smaller printers.
Both sizes work with either E14, E26 or E27 sockets. The middle opening fits the E26 / E27. For E14, just print 2 adapter discs (STL provided) , and place them above and below the narrow neck inside the shade.
You can get the power cords from Amazon here: For Europe: E27 cord: https://amzn.to/3OVrZjK E14 cord: https://amzn.to/3TchBqs
For the US: E26/E27 cord: https://amzn.to/3U0Xyvy
Happy printing!
DIMENSIONS (Large) | Ø200 mm x H 250 mm
DIMENSIONS (Small) | Ø168 mm x H 209 mm
3D PRINT SETTINGS
The shade prints upside-down (STL files already oriented properly).
The shade prints in standard mode, not vase mode. No supports required. No infill required.
Wall line count: 2 top layers: 2 Bottom layers: 3 Resolution: 0.2 or 0.3mm or less Build adhesion type: Brim 4 to 6mm Supports: None Infill: None (0%)
The shade on the pictures was printed with some “fuzzy skin”.
- fuzzy skin thickness: 0.25mm
- fuzzy skin point distance: 0.8mm