NINA | Toothbrush cups

Over time, the bottoms of toothbrush cups become increasingly dirty, water cannot drain out. And toothbrush heads usually end up touching, which isn’t very hygienic. Toothpaste tubes also tend to fall over, even though they’d be more stable standing upright in a cup.

So I designed a cup that solves all of these problems.

This cup is available in 3 versions: • for 3 brushes • for 4 brushes • for 6 brushes (or a couple of brushes plus razors etc.)

It prints in vase mode and takes between 1h to 1.5h.

DIMENSIONS | Ø110mm x H 110mm

3D PRINT SETTINGS: The cups print upright, in vase mode. The STL files are already oriented properly.

For a 0.8mm nozzle: • activate "vase mode" (spiral vase or spiralize) • Layer height: 0.4 mm/layer • Line width: 1.5mm • Bottom shell layers: 0

For a 0.4mm nozzle: • activate "vase mode" (spiral vase or spiralize) • Layer height: 0.2mm/layer • Line width: 1mm • Bottom shell layers: 0