All STL files are already oriented properly.

It can be printed with either a 0.4 or 0.8mm nozzle.

You need to print 2 parts:

• a **base**

• a **bowl**

**BASE:**

The base prints upside down.

To get the gyroid mesh that allows the fruits to breath, you need to **cancel the top and bottom layers**, only keep the walls and the gyroid infill.

**For 0.8mm nozzle:**

• use 0.3mm/layer

• 2 wall perimeters

• gyroid infill at 30%

**For 0.4mm nozzle:**

• use 0.2mm/layer

• 2 wall perimeters

• gyroid infill at 30% to 40% (adjust as needed)

• gyroid line width: 0.6mm

• first layer line width: 0.6mm

Add some fuzzy skin to add some surface texture:

• fuzzy skin point distance: 0.4mm

• fuzzy skin thickness: 0.25mm.

**BOWL**

The model appears full, that's normal.

You need to "empty it" by canceling the top and bottom faces (top and bottom layers set to 0).

Set the **layer height** to 0.3mm.

(ignore the warning if it says you cannot go over 0.28mm/layer)

**For 0.8mm nozzle**, use 2 to 3 perimeter walls.

(2 is breathier, but 3 prints a little nicer)

**For 0.4mm nozzle**, use 4 perimeter walls.

**Layer height:** 0.3 mm

**Top layers:** 0

**Bottom layers:** 0

**Infill:** none

**Build adhesion type:** None

**Supports:** None

For Bambu Lab users, make sure to:

- set "wall generator" to "arachne".

Happy printing!