Need some organization with a modern twist? Need something to raise your plants to the next level? This decorative tray will do the job!
Print Settings For the legs I printed them at 25% infill at .2mm layer height. I used a raft to make sure they were steady while printing. You can add support on the build plate if you wish but I printed them without supports.
For the tray I printed it out at .2mm layer height with 15% infill and no supports.
For the insert. I printed it out at .15mm layer height with 15% infill. If you want more detail on the insert you can print it at lower layer heights but will add more time to your print.
This tray can also be scaled to be bigger if you wanted as well! Just make sure to scale every part at the same %!
Assembly You will need to print 4 of the legs. You will thread the legs into the tray until they are tight. They may need some minor sanding or some grease/lubrication to thread on. This is due to how low/high your first layer settings are for the tray.
The insert can be placed in and glued if you wish. It pressure fits into the tray but may need some minor sanding to the edges to fit to your liking.
Happy Printing!