this lamp is printed in place and doesn’t require supports. It is not necessary to use the brim or raft. Good calibration and retraction is necessary for a great result.
Thin, hollow areas are present; if the nozzle were to hit these areas, they could break during printing. Therefore, a Z-hop between 0.4 and 0.8 is necessary and essential.
NOZZLE: 0,4 mm. LAYER: 0.16 – 0.20 OUTER WALLS: 2 INFILL: 10% SUPPORTS: NO Z-HOP: 0,8
For personal use only All my files are protected by Copyright, should NEVER be shared, resold or remixed. To sell physical print of my design and if you want to get the latest Models and exclusive designs subscribe a membership plan.
Categories:
21 Likes2 DownloadsApril 5, 2024