The Rising Phoenix of Fire - Set of 3 Bookmarks
byBooneCo3dSharing an older set of bookmarks. Took them and used updated setting in hueforge.
For these Models:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 68.33x205mm in size You may print at higher layer heights below the Min Depth of 0.24mm The Max Depth is 2mm and the Actual Depth is 2mm
Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Matte Scarlet Red Transmission Distance: 2 PLA BambuLab Matte Mandarin Orange Transmission Distance: 3 PLA BambuLab Basic White Transmission Distance: 6 This print uses 4 unique filaments
Swap Instructions: Start with Black At layer #5 (0.48mm) swap to Scarlet Red At layer #9 (0.8mm) swap to Mandarin Orange At layer #16 (1.36mm) swap to White for the rest.