tracking pixel
Michael M

Fanart Clockface - The Evil Smile of DC Villain the Joker - Animate

by
BooneCo3d
Follow
Follow
Remix Model
BooneCo3d
BooneCo3d
|
Image 3 of 3
Fanart Clockface - The Evil Smile of DC Villain the Joker  - Animate 3d model
BooneCo3d
BooneCo3d
|
Image 3 of 3
Fanart Clockface - The Evil Smile of DC Villain the Joker  - Animate 3d model
2D
3D
Makes
Fanart Clockface - The Evil Smile of DC Villain the Joker  - Animate 3d model
Fanart Clockface - The Evil Smile of DC Villain the Joker  - Animate 3d model
Fanart Clockface - The Evil Smile of DC Villain the Joker  - Animate 3d model

A new clockface to share with everyone. This is obviously the DC Comic Character the Joker, Nemesis of Batman.

If using the 3mf, note that there is a negative column to create the hole for clockwork. Remove if you want it whole.

This is 1 of 3 clockface models being shared today. Make sure to like, download and share your prints this week!

For this Model:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 226.46x225mm in size You may print at higher layer heights below the Min Depth of 0.32mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Matte Dark Blue Transmission Distance: 1 PLA BambuLab Basic Green Transmission Distance: 2 PLA BambuLab Basic Beige Transmission Distance: 8 This print uses 4 unique filaments

Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Dark Blue At layer #12 (1.04mm) swap to Green At layer #17 (1.44mm) swap to Beige for the rest.


7 Likes40 DownloadsSeptember 20, 2024


7 Likes40 DownloadsSeptember 20, 2024