Week 15 - A different idea I ran with and developed. What if you had to store Pokémon? Some would be in jars and others could be for light.
For these Models:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 65.03x205mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #11 (0.96mm) swap to Yellow
At layer #18 (1.52mm) swap to Jade White for the rest.
