Double 3D Pokémon Pikachu Star Wall Clock and clockface - FanArt
byBooneCo3d
_New Design to share with everyone! _
Pokemon pet star Pikachu shines in this new 3d clock. 3d in two ways with the plates being done in hueforge and Pikachu standing off from the back.
**Made of 3 printed parts in separate files. **
-
The back is a traditional clock face with a hole added to center (done via negative pieces in the .3mf file) to add the clockwork riser (box).
-
This box can hold a simple gearwork setup similar to the mechanism offered by bambu and amazon.
-
The artwork on the front which is Pikachu here. With a hole added (or drilled after), he is added to the box and tightened down with the mechanism nut.
This provides the opportunity to change out the front artwork to whatever you want. Just add a hole and replace it on the mechanism.
Each file has its own parameters:
Box is printed in Black
Back clockface:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.32mm
The Model is 220x220mm in size You may print at higher layer heights below the Min Depth of 0.32mm The Max Depth is 3mm and the Actual Depth is 3mm
Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments
Swap Instructions: Start with Black At layer #11 (1.12mm) swap to Blue Gray At layer #16 (1.52mm) swap to Beige At layer #26 (2.32mm) swap to Jade White for the rest.
Pikachu Artwork (if you want less white and more yellow, increase the height of the change to white):
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.32mm
The Model is 87.43x100mm in size You may print at higher layer heights below the Min Depth of 0.32mm The Max Depth is 3mm and the Actual Depth is 2.3mm
Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Matte Ivory White Transmission Distance: 3.5 This print uses 4 unique filaments
Swap Instructions: Start with Black At layer #7 (0.8mm) swap to Red At layer #12 (1.2mm) swap to Yellow At layer #23 (2.08mm) swap to Ivory White for the rest.