Asian Ink Design - Beauty with Hair blowing in the Wind - Hueforge Art

next model for Friday - an Oriental design of a woman walking and the wind blowing.

For this model:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 210x210mm in size You may print at higher layer heights below the Min Depth of 0.32mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments

Swap Instructions: Start with Black At layer #5 (0.48mm) swap to Blue Gray At layer #10 (0.88mm) swap to Beige

Border Only Colors from here until the end. At layer #21 (1.76mm) swap to Jade White for the rest.