Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5272598.

My first 3d model and first print from my Anycubic Vyper
I probably should have started with the owl

In theory you have the Vyper so perhaps skip right to the gcode...

Included the STL and a 95% decimated STL 

Also included an STL of the profile in case you want to make your own without wasting as much time as I did getting the dimensions right. 

I hope it works for you

131mm tall
76mm wide
13mm beveled corners

walls about 2.5mm thick
thinner in the beveled corners 



Screen Cover Anycubic Vyper

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5371328.

A 3D version of the traditional Biohazard symbol with a stand.

Do yourself a favor and write down the exact scale you print at just in case you want the stand to match.

For FDM printing I recommend printing no smaller than 120mm tall. The support in the middle and the thin edges become hard to deal with smaller than that. 

I printed this as per the attached Cura project with custom and tree supports and quite a bit of tweaking. 

All the overhangs make me wish I had a resin printer.

There is no difference in the Sphere from V15.3.7 to V16.3 those releases are about a matching stand. 

In the picture I am using the 16.3 stand with the 15.3.7 sphere

Biohazardsphere

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5363764.

Like the cubes from the cover of 
Gödel, Escher, Bach: an Eternal Golden Braid
by Douglas Hofstadter

This was just a project in learning to bevel for me


GEB Cube

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5363771.

Like the GEB block but with GRS instead
perhaps that works for your initials

I played a bunch with supports etc for a clean print so I included the cura project 

GRS Block

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5396514.

Perhaps you have a Spirit Halloween Jumping Spider
it may have broken eventually like mine did

Here is a part to try to fix it. 

I and going to stake mine to the ground via the large holes
you might want to glue it to the original case, or use the holes to screw it together
Watch for internal bits before using the holes to screw it together your might have electronic parts in places mine doesn't

I printed with 5 walls so the box is solid, and a 25% gyroid fill so it's strong



Jumping Spider Part

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5277618.

remastered EGO Battery Holder by don3sch June 03, 2016

Hangs the battery 30 degrees off the wall so you don't need so much space above to get the battery off

I did include larger holes in the face to get a screwdriver in, then it gets smaller about 1/2" from the wall side for the screw. 

I used 2 Inch #8 Pan head screws and small washers to mount to wall. 

I printed with a brim and a couple of manual supports on the sloped side. 
Prints kinda like an inverted pyramid. 



EGO Battery Holder

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Bio_

Achievements