Here is the 4 mazing race, this super fun marble game is a modular marble race puzzle game with 1-4 players able to connect there base's to race and beat the other players. Rules are set by you, there's 3 main ways to play the game, first is simply connect 4 of your coloured marbles in the middle before the other players do first person to have a row of 4 wins, option two is connecting two court ramps, two walls and two extensions to make a 2v2 soccer game first person to score two marbles in the other players base wins, the third option is to have an instant win hole in the centre first player to sink one of there coloured marbles in the middle hole wins but each player gets 1 hole filler and can choose to fill any hole on the playing field, but there's 4 instant lose holes surrounding the centre hole, you can label them with a permanent marker which ones are as such, I recommend the 4 directly surrounding the centre hole. Print settings No supports needed for the piece's but the Swizzle turret, for the swizzle turret use tree supports, overhang angle 70%, support density 10%, support pattern Gyroid, Layer height 0.2mm, Print speed 50ms, Infill density 15% or higher, outer walls 3 minimum, Nozzle size 0.4mm, Make sure to clean off the elephants foot around the connections, depending on filament type you may not need to clean it off at all so check the fit first, there's also a little tab on the ramp that helps to add strength but may make the piece too tight if so just run a blade or knife along the edge to clean off extra filament.