BigBoomPrints799 followers

Lego hand phone holder

30 downloads · 6 months ago · Here is Lego hand phone holder, This awesome Fan Art design is designed to look like a Lego hand and

Description

Here is Lego hand phone holder, This awesome Fan Art design is designed to look like a Lego hand and comes with an adjustable swivel mount that fit most smartphones, This design also comes with a channel that runs through the entire design to allow you to charge your phone while on the stand. Assembly to assemble the design first print off the size that suits your phone Small should fit Iphone X up to iphone 17, the medium should fit most phones larger than the standard with a case, The XL size should fit all large phones and up, Most people should fit the Small size. Next attach the Base to the Wrist Joint this will be tight, it needs to be tight to hold the phone in position, I recommend Lightly using a heat gun on the base to make things easier, Next slide the left hand side into the right hand side of the hand make sure to get the hands into the position for the phones the phone size before adding the screw, Next attach the base and wrist joint into the back of the hand, this part is an oval so twist clockwise until tight if it's not tight enough you can add some glue at this step, Next push the wrist into the stand, The wrist is also an oval and if turned it should tighten, Then insert your charging cord through the channel and hole, this can be done at anytime Print settings, Nozzle size 0.4mm, Layer height 0.2mm, Infill 15%, Wall count 3, Supports needed for the hands and the stand, Support type normal, support overhang angle 10%, Brim No, rafts No,