Here is Crystal Nintendo switch dock, This awesome decoration comes ready to print no supports needed, no glue, and fits any printer, Just print the left side and the right. To assemble just clean the holes from any printer marks, an push the left side into the right, when pushing the two half's together just move the right side up and down to force to hard it should be firm to push together then click if you start to hear cracking stop and clear the holes some more with a blade or Dremel. Printer settings it can be printed without supports but it wouldn't hurt to and supports for the left side to get the perfect joint, support type normal, support over hang angle 70%, support density 8%, Nozzle size 0.4mm, layer height 0.2mm, Print speed 50ms, Infill 15%, infill pattern grid.