Meet my next floppy installment! The floppy stocking!

Printing Instructions: IMPORTANT: Stocking Bottom.stl and Stocking Top.stl are meant for printers with MMU or AMS connected to them. You must import them just like I have instructed below. Otherwise, use Stocking.stl

The 3mf files provided were created using Prusa Slicer and Bambu Studio respectively and should have the following settings already configured.

• Layer height: 0.2mm
• Wall loops: 3
• Supports: None!

I like to print it at a larger scale because who doesn't want a big floppy stocking? The one in the photos was scaled up to 150%

If using Stocking Bottom.stl and Stocking Top.stl: If you don't use the 3mf files, when importing the STL's into your slicer, make sure you select both Stocking Bottom.stl AND Stocking Top.stl before selecting "Open". The slicer will then ask you if you want all files to represent a single object. Make sure you select "Yes"

You will then have the option to change the color of Stocking Bottom and Stocking Top according to your liking.

Make sure you have your build plate nice and clean to avoid adhesion issues. Either clean it with an ammonia based cleaner like Windex or clean it with high quality dish soap and warm water. IPA also helps, but not guaranteed to work.

Thank you for your time and consideration on this matter.

Feel free to join my discord for additional support, questions, or suggestions!