Sandpaper Organizer with Engraving and Dremel Shank Storage

This is a simple sandpaper organizer designed to hold 1/4 sections of 8.5x11" sandpaper sheets (so, cut down the middle both ways). Each section has a vertical storage section as well for those that use thin strips as frequently as I do.

The front panel has three 2.7mm holes for engraving pen tool shanks, and three 3.2mm holes for standard Dremel bit shanks.

Blowpipe Threaded Stock

Stock.stl

G Flemish Border pipe, sectioned under 180mm

Body1.3mf

Rudall & Rose #5501

upper main.stl

Medieval Musa

MusaMedieval.STL

Membrane Reed Bagpipe Chanter

Inner.stl

Bore Gauge Stopper

Cheap bore gauges tend to need quite a bit of force to lock, during which time it's easy to shift the measurement point. This stopper uses a 4mm nominal bolt to fasten to any gauge with a 4.6mm shaft.

I am a musician and researcher seeking to make both historical and modern-traditional instruments more accessible to everyday people, with the end goal of having an extensive 3D-printable instrument library, with documentation on each piece as well as recommendations and guidelines for building and playing them!

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

Barter Loch Woodwinds

Achievements

Seedling

Debutant