A

2.5 SSD USB Drive Case

by
Azega
Follow
Follow
Remix Model
A
Azega
|
Image 3 of 6
2.5 SSD USB Drive Case 3d model
A
Azega
|
Image 3 of 6
2.5 SSD USB Drive Case 3d model
2D
3D
Makes
2.5 SSD USB Drive Case 3d model
2.5 SSD USB Drive Case 3d model
2.5 SSD USB Drive Case 3d model
2.5 SSD USB Drive Case 3d model
2.5 SSD USB Drive Case 3d model
2.5 SSD USB Drive Case 3d model
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5714430.

This is a way to use the controller board from a shucked 3.5" WD Easystore drive to make an external USB3 case for a 2.5" drive. There are two different bottoms, one for 9mm thick drives and one for 7mm thick drives. The two halves snap together so it doesn't require any fasteners.

I had to file off a little of the corner of the board so it would fit with the rounded corners of the case without needing to increase the size. 

I printed it in clear filament because I thought it would look nice and to see the LED. You could print in an opaque filament and drill a small hole for the LED.

Suggested print settings: 0.28mm layer height, 0.6mm line width, no infill, no support.


1 Likes4 DownloadsDecember 15, 2022



1 Likes4 DownloadsDecember 15, 2022
This model is restricted by licensing terms.