Lantern

A lantern in 3 parts

Depending on how good your printer/filament can handle bridging, you can probably print all of this without supports - I did

Other that it can be printed with just your standard settings and the lantern itself should be printed in vase/spiralise mode with no top or bottom layers

This lid should be printed upside down with the top of the lid on your print bed - this eliminates the need for supports for this piece

There is space in the base to sit an electric tealight and also a cut out for the lantern to sit in so it won't shift when moved

The lid should fit snugly though tolerances will vary a little by printer. There is a notch in the lid to help with removing it