Hello! Recently, I've encountered issues with my cutlery not fitting into standard dish racks. Since my cutlery is small, it either doesn't fit or falls over. To address this problem, I've designed a solution. This also accommodates larger cutlery.

This organizer serves a triple purpose! It not only fits all your cutlery for drying but also holds dirty cutlery, eliminating the need to just throw it in the sink, it also makes it easy to put away cutlery. Naturally, it features drain holes, essential for proper functionality.

Please note: This organizer is designed for use with dual-sided sinks. If you require a version for single-sided sinks or have any other ideas, please feel free to message me.

The organizer is intended for use by: Dumping your cutlery into the sink, rinsing the organizer, then flipping it to the other side to store the clean cutlery. Once the cutlery is dry, you can move the container closer to where you store your cutlery, eliminating the need to grab handfuls of knives, spoons, and forks.

If you have a larger sink divider and require a customized organizer, please message me, and I'll be happy to create one to fit your sink.

Important: Materials, Dimensions, and Sealing

Please verify these dimensions before printing: Ensure your sink has a depth of at least 80mm (8cm or 3.15 inches) and that your divider is smaller than 35mm (3.5cm or 1.38 inches).

Material: Please use a heat-resistant material such as PLA+, PETG, or ABS.

Sealing: It's essential to seal this organizer before use, as bacteria can accumulate in the layer lines, making it unsafe for food. Using a sealant such as Food-Safe Epoxy Resin or FDA-Approved sealants is necessary.

Use at your own Risk!

3D printing settings 10-15% Gyroid Infill 25 or lower Bridge Speed 2-3 Walls it doesn't need support but can result in messy finish