Tevo little monster spool holder

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2954920.

Not all of my filament spools fit the shaft of the original Tevo little monster spool holder. I therefore designed a multi-spool holder where I re-used the bracket. It is made so I only need to make a new shaft if I get a filament spool with other dimensions. The only thing that must be applied to each new shaft is the key width (square at the end of the shaft 10 mm x 10 mm)

You need the following 3D printed parts:

1 EA Baseplate.stl 2 EA Tension nut 1 EA Spool shaft Ø19 MM.stl

You will need the following hardware parts:

2 EA M4 nut 2 EA M4 x 40 hex bolt 1 EA Rubber sheet for friction (2mm x Ø45mm rubber with Ø4.5mm hole in center)