tracking pixel
AllTheBuz3D

Demon Slayer Mask - Tanjiro Cosplay

by
AllTheBuz3D
Follow
Follow
Remix Model
AllTheBuz3D
AllTheBuz3D
|
Image 14 of 14
Demon Slayer Mask - Tanjiro Cosplay 3d model
AllTheBuz3D
AllTheBuz3D
|
Image 14 of 14
Demon Slayer Mask - Tanjiro Cosplay 3d model
2D
3D
Makes
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
Demon Slayer Mask - Tanjiro Cosplay 3d model
This model is restricted by licensing terms. 

Demon Slayer Tanjiro Mask for Decor or Cosplay.

3D printing settings used: Bambu Slicer 0.16mm standard setting Size: 175 x 97 x 247 mmm Suggestion: I print the mask standing up so the layer lines end up at the bottom vs if you lay it flat with supports on the inside of the mask (you'll have layer lines on the middle of the forehead and middle of cheeks which will be visible when worn).

For the eyes I paused my print midway (see photo or use 3mf file) and added tulle fabric and resumed the print, this way the tulle was imbedded in the eye print.

The mouth sparse infill is set to 30% so it doesn't bend/break when removing supports.

The cheek's sparse infill is set to 20% so it doesn't bend/break when removing supports.

Everything else is set to an 8% sparse infill.

The top of the pupils have a concentric top surface pattern so it follows the geometry's circular pattern.

If you use the 3mf file for bambu all settings and orientations are already set.


0 Likes0 DownloadsSeptember 13, 2024


0 Likes0 DownloadsSeptember 13, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.16mm

MaterialPLA
Layer height0.16 mm
Infill density8 %
SupportsTree