tracking pixel
André C

bathroom towel bar adapter

by
A.Coval
Follow
Follow
Remix Model
A.Coval
A.Coval
|
Image 1 of 8
bathroom towel bar adapter 3d model
A.Coval
A.Coval
|
Image 1 of 8
bathroom towel bar adapter 3d model
2D
3D
Makes
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
bathroom towel bar adapter 3d model
This model is restricted by licensing terms. 

a simple piece to connect a bar that was from a closet, just pop one of this, in each side of the bar. i used strong double sided tape to attach the adapters to the wall. super clean, there is no need for supports just print the piece on the orientation of the 3d photo (flat side down).

*side note: this piece has a 1mm socket for double side tape, if your double side tape is thinner, just cut a 1mm piece in the slicer (its easy nowdays) and it becomes flat, or cut the right height for the tape. It was just a way to hide the tape joint to the wall, more clean look.

i recommend print in PETG but for indoors, PLA is just fine. regular print, .2 layer, regular infill.


1 Likes8 DownloadsApril 25, 2024



1 Likes8 DownloadsApril 25, 2024
This model is restricted by licensing terms.