This model is restricted by licensing terms.
View license.
Have fun with this little wave toy. See it in action here: https://vimeo.com/725552445
It prints in place, without supports. When you have finished the print take the base off first and push onto the main model, this will give you a bit of stability before removing it from the bed.
Make sure you can see the strings down the centre in your print preview.
I recommend a layer height of approx. 0.3mm
Categories:
205 Likes1K DownloadsJune 30, 2022
205 Likes1K DownloadsJune 30, 2022
This model is restricted by licensing terms.
View license.