3dprintbunny

Select a membership plan

Monthly billing

17% off

Supporter Plus

Supporter Plus

$8.33

/ month

when billed annually

This supporter plus plan gives you:

A MASSIVE thank you for your support
Access to a small library of exclusive designs including my Hot Air Balloon and Carousel designs
One new exclusive design monthly
Opportunity to suggest and request new designs
Advice and support

Immediate access. Cancel anytime.

17% off

Commercial Print & Sell

Commercial Print & Sell

$9.96

/ month

when billed annually

This membership plan gives you the right to print and sell any of the 3DPrintBunny designs available for download on the Thangs website. It also gives you the right to print and sell any 3DPrintBunny design available on any other website (Printables, Makerworld etc). These rights are limited to the duration of your membership

You also get:

Access to a small library of exclusive designs

this membership does not permit the use of any 3DPrintBunny design to promote products other than the design itself*

Immediate access. Cancel anytime.The models in this plan are restricted by licensing terms. View License.

3dprintbunny24K followers

Follow

Caged Birds String Ornament 2 3d model

Caged Birds String Ornament 2 3d model

Caged Birds String Ornament 2

911 downloads · 3 years ago · Caged Birds String Ornament Print the bird at 0.2mm or lower layer height without supports Print t

This model is restricted by licensing terms.

View license.

Caged Birds String Ornament

Print the bird at 0.2mm or lower layer height without supports

Print the cage at 0.3mm layer height without supports (for Bambu Studio make sure wall generator is set to Arachne)

I also have a single bird version with a different cage which you can find here: https://thangs.com/designer/3dprintbunny/3d-model/Caged%20Bird%20String%20Ornament%201-776913

The stand can be found here: https://thangs.com/designer/3dprintbunny/3d-model/Stand%20for%20Caged%20Bird%20String%20Ornament-776912

Community Makes (2)

Make by user

love it, thanks N.

Make by user

love it, thanks N.

Community Makes (2)

Make by user

love it, thanks N.

Make by user

love it, thanks N.

Discussions

rumori5803 years ago

hello, good job.

alexjsmith6003 years ago

PETG at 40mm/s printed perfectly until the top, the overhangs were too steep

Armour 3 years ago

Thanks for adding the info on Bambu Studio much appreciated.

robarichard3 years ago

How can you actually print the cage? I can't visualize a way the "wires" would ever work out

Pugdad3 years ago

The wires actually printed perfectly. However without supports, it became way too wobbly near the top and it just didnt work. I'm going to try again with some manual support and hopefully it will come out ok.

Caged Birds String Ornament 2

911 downloads · 3 years ago in

Home Decor & Accessories

and

3dprintbunny24K followers

Follow

This model is restricted by licensing terms.

View license.