Harry Potter, Harmonie, and Ron themed lightbox pen holder; I've made many lightbox designs so far. In each design, I try to experiment with something a little different and unusual. I've included holes on both the right and left sides for LED strip connections. You can choose whichever side is convenient for you. I've also added a cover to close the other hole. Inserting the LED strip inside might be a little difficult. You can use tweezers for this. I've added a softbox for even light distribution. This is an optional feature. Start by attaching the right softbox, then the middle, and finally the left side. The covers fit quite tightly. This may vary depending on your device's tolerance values. You can also glue them on. I don't recommend putting too many pens in. Because it's an angled design, the center of gravity is towards the back. Happy printing everyone…

🔧 3D Paint Lab is now on Patreon!

If you enjoy my designs and would like to support this creative journey, you can now do so through Patreon.

There are several support tiers available — from symbolic contributions just to say “thank you,” to full Commercial Licenses that allow you to sell physical versions of my models.

📦 About the Commercial License: If you want to produce and sell physical prints of my designs, you’ll need a commercial license. You can get it easily through my Patreon page.

https://www.patreon.com/3dpaintlab 🚫 Please Note: Sharing, re-uploading, or selling my digital files without permission is strictly prohibited.

All designs are protected under digital licensing, and legal action will be taken in cases of unauthorized use.

🎯 Your support means the world to me and helps keep the daily design flow alive. Thank you in advance!