Sword is designed to store 1 set of DnD dice (D20, D12, D%, D10, D8, D6 and D4) set where D20 size is 20mm from the flat sides, or 23mm in diameter from the corners.
Object to print:
1xBlade - available in two versions
1xGuard - only needs supports
1xHandle
4xConnector
1xPommel
1xScabbard
Notes before printing:
Almost all files can be printed without supports. Add supports only to guard.stl (while doing so, be careful not to add supports to the center of the holes)
I recommend printing guard.stl and blade.stl files with a maximum of 15% fill. This is due to the fact that the joining should fit well
Joining blade.stl and guard.stl is very simple. You don't need to push the connector completely into the piece, insert it so that it doesn't fall out and then join the two pieces together
