This model is restricted by licensing terms.
View license.
66 Likes132 DownloadsApril 5, 2023
This model is restricted by licensing terms.
View license.
An alternate core for the Rollup Dice Box that turns the core into a dice tower.
Options
- Size - Small and Large towers are available.
- Add 6x3mm magnets - Magnets help keep the internal core of the tower in alignment.
- Base - Add the base to keep dice from rolling away.
Printing
- Most standard PLA formulations are fine, but avoid brittle silk and matte PLAs.
- All parts can be printed without supports.
Assembly
- (optional) Glue 6x3mm magnets into the bottom tower frame and tower core. Make sure magnets are aligned so that the core is pulled into the frame.
- Slide the tower core into the bottom tower frame.
- Firmly press the frame top into the frame bottom. These parts are a very tight fit and may require a lot of force to close. To avoid damaging either part, apply pressure only near the center of the top and bottom frames.
Can I sell copies of this?
Yes! This project was shared under the Creative Commons - Attribution license.
This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.
Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.
This license applies only to the model files (STL, 3MF, STEP, F3D) included in this project. It does not apply to photos, videos, my logo, or other supplemental graphics attached to or displayed with this project.
Category:
66 Likes132 DownloadsApril 5, 2023
This model is restricted by licensing terms.
View license.
66 Likes132 DownloadsApril 5, 2023
This model is restricted by licensing terms.
View license.