A ready-to-solve twisty puzzle box.
Printer Requirements
This is not a difficult print, but it does require a fair amount of accuracy.
All moving parts have a clearance of 0.5mm, so your printer must be accurate enough to avoid fusing together parts that are positioned close to each other.
All functionally important overhangs are limited to 45 degree angles. Your printer must be able to print these overhangs cleanly.
Any stringing or large surface imperfections my make this puzzle impossible to solve.
If the above requirements cannot be met, some parts of the puzzle can be printed separately - most obviously the outer case. Doing so will, of course, spoil the puzzle mechanism.
Options
- Optional Stand
- Optional DK Logo
Printing
- Do not print with supports
- Print at reasonable speeds
- Use filament that won't blob or string Make sure your print bed is prepped and cleaned for optimum bed adhesion If you add a fuzzy skin texture to the print, ONLY add it to the exterior of the outer shell.
Verify a Successful Print
-
After printing the main puzzle and the puzzle key, you should be able to tell if your puzzle is solvable by checking the following:
-
The puzzle will rattle easily when shaken. Parts on the bottom of the puzzle will wiggle when lightly pushed.
-
The largest concentric circle on the bottom of the puzzle can rotate by hand.
-
The key will fit inside the key hole in the bottom of the puzzle.
-
The key will be able to rotate after its inserted into the bottom of the puzzle.
Assembly
Just slide on the separately printed barrel hoops - no glue needed!
If printing the optional stand, secure the stand pieces by gluing them together or by inserting a short piece a filament as a “pin”
If printing the optional DK logo, glue the logo stem onto the side of the barrel where desired and glue the logo onto the stem. The logo can be oriented horizontally or vertically as desired.
Spoiler Alert: Puzzle Solution https://www.youtube.com/shorts/yY4Uzi4Dof8
Can I sell copies of this? Yes! This project was shared under the Creative Commons - Attribution license.
This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.
This license applies only to the model files (STL, 3MF, STEP, F3D) included in this project. It does not apply to photos, videos, my logo, or other supplemental graphics attached to or displayed with this project.
Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.
This license also does not cover the optional “DK” Donkey Kong logo. Prints of that logo cannot be sold due to being based on an existing IP.