Smooch Skull - This was inspired by a meme I saw a few months ago and I thought it would be funny to turn it into a 3d print 🙂

The skull has 6 variations and they are described in the file names, basically the options are:

• With PLA eyelashes
• With printed eyelashes
• Without eyelashes

And each variation comes with or without sunglasses. No need for multicolor printer. Optional - Inside the lips you can place 10mm x 2mm magnets so the lips lock (I left some space so it's not too tight)

Printing & Assembly:

Skulls - They can actually be printed without supports but for better visuals you might want to add some at the bottom of the skull and where the upper jaw ends. Make sure you do NOT place supports inside the jaw ball joints.

Print the lips without supports - Check your slicer to pause 1-2 layers before the magnets placeholders are closed. Sunglasses and shades without supports.

If you use PLA for the eyelashes use a heat gun to "comb" them up so they get a nice shape. The holes for the PLA are a bit bigger than 1.75mm. Each lip must be glued to the skull.

Print the lips with red TPU for extra sensual look 💋 And as the lips lock with magnets these can actually be used as note holders 😅

Scaling up & down is not a problem just take into account the size changes of the lips magnets and PLA eyelashes holes.