Screaming Pepper

Sometimes you get ideas from day to day routines - Like cutting a salad and seeing one of those screaming bell peppers 🫑😱 As the name suggests this is the Screaming Pepper which I think can go nicely with the Bad Avocado 😉

There are A LOT of files here so please read the instructions before you print:

• The model comes with 2 Stem versions - With or without place for magnets. The magnets version has an insert for a 12mm magnet to hold the pepper closed - It's not VERY strong but it's enough to hold it nicely.
• The Pepper has 2 faces on each side so you'll always see Pepper 1 & Pepper 2 in the files
• There are versions with the Stem separated from the pepper which will allow you to print multi color without AMS - With the separated stems versions you will have to use glue to stick StemBP1 to Pepper1 and StemBP2 to Pepper2. These versions are also better looking as printing the stem vertically looks better than laying down.
• Alternatively you have precolored AMS and non-AMS versions with the stem already connected - Do mind that with that version the orientation is worse in terms of quality of the stem + more AMS poop + You will need tiny supports for the magnet insert so it does not stick out too much due to bridging.
• Supports are NOT required except what I mentioned above.
• Do NOT use a brim or raft
• Teeth can only be colored using AMS or by hand if you are feeling artistic (It's super easy 5 minutes work)
• AMS precolored 3mf and non-AMS files included for Eyes. You can also color them without AMS by switching filaments mid-print. As with stems each Pepper has it's corresponding eyes.
• Included a Stand as well if you want to print the No Magnets version and have it standing nicely - Can also be used with the magnets version.

Scale:

You can scale up or down just take into account that:

1. when you scale down the tolerance for the eyes will become tighter so as you scale down you might want to scale the eyes down a bit more.
2. The 12mm magnet insert will become smaller so if you want to fit a 10mm magnet you can scale it down to approx. 85% - I'll leave the math to you with other sizes :)