Hey Folks!
This one was sort of a test and experimenting I did with several Ideas that turned into this cool looking popcorn box which is printed in 3 parts.
Please read the instructions for successful print!
-
At 100% scale the white.stl part has some very thin areas at the bottom that may start to wiggle when the nozzle starts reaching the top - You can try adding custom supports on the sides with a close offset as you can see in the last image I added but eventually if your nizzle pushes them hard they may wiggle and end result will not be very smooth at the top.
-
Stringing - Simply because there are so many bounces between the white stripes here you may have some stringing so watch out as well - nothing that a good heatgun can't solve
-
The Popcorn cover has some floating areas on the popcorn itself but you can (And should) ignore them - final result is good! Except the edges of the lid itself - So setup your supports for "Touching Buildplate only" or place a support Blocker above the edges.
-
You gotta use some glue on the edges once you slide one part into the other because it will not hold by itself.
-
The tolerances is tight but not too tight, the inner box should slide inside and then push it in with some force.
-
Scaling up - no problem. Scaling down - wiggling of thin areas will be more substantial.