The floating puke emoji is all sobered up and it's successor is here 🤑 This one also floats in the air using it's tongue - But this time this is a totally functional Piggy Bank. All parts are printed separately including the $ signs so you can mix all sorts of colors without a multi-color 3d printer.

Dollar and Dollar smaller are the same just 10% difference in size 2 tongue versions one with embedded $ and one that you can insert a different color

I included a Flat base version and a full version - Both are oriented in the best way I found. Flat version CAN print without supports (All images printed without supports) BUT it depends on your cooling and speeds so you might wanna put a tiny support on the lip part just in case. Make sure you DO NOT place supports inside so make sure support placement is on Touching Buildplate only (Cura) - See attached image.

a. Printing the full version will obviously require supports on the bottom b. You can push it towards the buildplate if you want a bigger base

c. Both versions have very high overhangs on the bottom (It's a sphere after all) if you want it to look good on the bottom as well I'd advise to print slowly, or do section b :)

Either way - all the tough overhangs are in hidden locations.