This is the Melting Snowman Ice-Cream Holder! It's completely multipart so no need for AMS or other multicolor systems. The holder has been tested with Ben & Jerry’s and Haagen-Dazs pints, but you may need to rescale it for your preferred brand. If the previous Ice Cream holders worked for you - This one will as well.

Printing:

The Cups (Smooth or Textured) require supports. Hand, Hat & Nose_bent_Melting also require supports.

Assembly:

• You can pick any variation from the available eyes and noses.
• Eyes can be printed in either Multipart or Multicolor.
• Connect the puff to the hat with some glue with the smooth area facing the hat.
• Eyes + Buttons + Hand + Nose also require some glue.
• MP files stand for multipart.

The hat is optional and it should fir the lid of the ice cream. Warning: If you push it too hard it may be a bit tricky to release the lid from inside the hat. Tip: if you want to print the hat test it by printing a few layers and making sure it fits the lid.

**Eyes Recommendations: ** Go with Eyes_Precolored_4 if you have AMS or the V1 if you are printing in parts - Those eyes are just the best looking IMO. If you have an off-white or just a different bright/whiteish color then use it for the eyes so it is different than the snowman's white. The multipart eyes might have some thin walls missing in top area when you slice it but do not worry about it.