Sexy hexy magsafe stand

For best result make sure the face where you insert the charger is the one touching the bed.

I needed a magsafe stand where the wire came out the front which is surprisingly hard to find.

I've included spots to add rubber feet to the bottom, but you can also tape it down for a more permanent solution. To add the decorative elements just use a bit of CA glue.

Materials: eSun PLA+ in black, eSun Matte PLA in mint green Settings: Infill - 10% Supports - yes Layer height - 0.15mm or 0.3mm if you want it done quicker